Menu
@mrjackson

5-928999-1 Female Unseal Pins Crimp Terminal

Original Part Number: 5-928999-1

LHE Part Number: 6206420001

Contact Tab Size Series: 0.64

Size (MM): L:13.6 W:1.8 H:1.8

Wire Range(mm²): 0.2-0.35

Material: QSN6.5-0.1

Thickness(mm): 0.2

Seal or Unseal: Unseal

Overview:

LHE PN: 6206420001
Certification: TUV, IATF16949, ISO14001, ISO9001, CQC, UL, ROHS
MOQ: Most product not have MOQ, Small order can be accepted.
Sample service: Free Samples
Delivery Time: 3-5 Days
Quality Control All goods will be 100% inspected before dispatched
Payment: T/T, Western Union, MoneyGram, PayPal; 30% deposits; 70% balance before delivery.
Shipment: DHL/FedEx/TNT/UPS/EMS/Aramex/SF for samples, By Air or by Sea for batch goods; Airport/ Port receiving.

Enquiry Form

    Interesting Products

    name

    Company

    Email(*)

    Tel/Mobile

    Address

    Tell us your needs (as specific as possible)


    The influence of copper alloy bending springback on the terminal size. During the bending process of copper alloy, the inner and outer layers of

    The existence of an elastic deformation zone where the stress transitions to compressive stress will inevitably cause springback after bending and unloading. The rebound characteristics of the copper alloy have caused quality defects of the terminal’s outer dimensions, which will affect the subsequent connector assembly accuracy in severe cases.

    The factors that affect the bending springback characteristics of copper alloys are as follows:

    ●Mechanical properties of copper alloy: the bending resilience of copper alloy is proportional to the yield strength of the material and inversely proportional to the elastic modulus . This is because the greater the yield strength of the copper alloy, the greater the stress in the material deformation zone and the greater the elastic deformation zone and the greater the rebound value under a certain degree of bending deformation. The larger the elastic modulus of the copper alloy, the smaller the elastic deformation zone of the material under a certain degree of bending deformation, and the smaller the rebound value. ●Relative bending radius (R/t) and bending angle: When the copper alloy is bent and formed, the smaller the relative bending radius and bending angle, the smaller the springback value after unloading, because at a certain degree of bending deformation, the plastic deformation area is large , The proportion of elastic deformation to the total deformation is small, the smaller the rebound value.