Minor defects cannot be detected
Defects such as broken 1-2 core wires, slight deep punching, etc., although reducing the tolerance can detect many defects, but at the same time, misjudgment will increase.
Make a sample of the defective product you want to detect, adjust the tolerance according to the actual situation, so that it can be detected, and test whether the misjudgment caused by this tolerance is acceptable.
Affected by the combination of terminal core wires, the state of the crimping machine and the mold, etc., various reasons are related to each other. The possible reasons are as follows:
●Electronic interference, abnormal pressure waveform.
When the electronic interference is large, the sawtooth will appear on the pressure waveform, and the sawtooth will also appear before and after the pressure waveform. In order to avoid problems, please always pay attention to safety grounding at the operation site.
● The stiffness of the press is reduced, or the base is unstable.
The wall-mounted PSS sensor is a sensor that detects the deformation of the crimping machine. If the crimping machine itself is unstable, please use the base-type FTW series sensor.