Dense winding of the tape in the wire harness: 1/2 and 1/4 overlapping windings are generally used for dense winding. After one dense winding, the tapes on the wires are respectively two layers and one layer, so that the tape can play a good role in the wire harness. The role of sealing and insulation protection makes the wires inside the wire harness not easily damaged by the outside world. This winding method is generally used in the wire harness in the engine compartment.
Interval spiral winding: when the tape is wound, the winding method is the same as that of dense winding. The difference with dense winding is that the wires are evenly exposed after winding. In general, the spacing distance is 0.5~2.0 tape widths of the actual tape width. , this winding method is generally used in indoor wiring harnesses.
Non-helical winding at intervals: The tape is not spirally wound during winding, and there are many bare wires exposed after winding, and the winding is uneven. Generally, the distance between the tape after winding is 80~200mm. This winding method is generally used for protection outside the wire harness. on the casing bellows.
Use of sponge tape: If the style of the sponge tape used is the same as that of ordinary rolled PVC tape, the winding method is generally 1/4 stacked and tightly wound. When the sponge tape used is a block sponge strip, use two ends to fold and paste Method, after pasting, use PVC tape to partially bind or use 1/4 stacked and tightly wound.