The branching manifold and the wire groove are located at the branch point. When used to fix the direction of the branch of the wire harness, it is necessary to match the appropriate pipe according to the aperture, and clamp the corrugated pipe to fix the direction. There is a length loss in the branching manifold and the trunking, and the setting of the margin should also be considered when using it.
The connector is the central structure for connecting wires and electrical appliances. It is the main component to realize the function of the wiring harness, and it is also the most expensive raw material in the wiring harness. Knowing the connectors used is very important to the process of the wiring harness. After the wire is crimped and inserted into the connector, a part of the length is lost inside the connector. At the same time, the connector with a tail clip will increase the length of the lost wire, so the rationality of the margin setting has a great influence on the length of the wire harness. Importantly, when calculating the process length, you must first understand the length of the connector and the end clip, and include it in the downline size.